Replacing A Summit X650 Dc Power Supply; Removing The Psu - Extreme Networks Summit X150 Series Hardware Installation Manual

Replacing a Summit X650 DC Power Supply

In a redundant power configuration, you can replace one Summit X650 DC PSU without powering
down the switch.
You need the following tools and materials to replace a Summit X650 DC PSU:
#1 Phillips screwdriver
●
Torque screwdriver and wrench or torque driver with attachments for tightening screws and nuts
●
ESD-preventive wrist strap
●
Thermal protective gloves (required for removal of a PSU)
●
WARNING!
Be sure to disconnect all power cables before you disconnect the chassis ground wire.

Removing the PSU

To remove an installed Summit X650 DC PSU:
1 De-energize the DC circuit.
2 Attach an ESD-preventive wrist strap to your bare wrist and connect the metal end to an appropriate
ground point on the rack.
3 Disconnect the DC power cables as follows:
a Slide the cover off the terminal block.
b Loosen the screws that secure the cable terminals to the terminal block.
c Slide the wires out from under the captive washers.
4 Disconnect the ground wire as follows:
a Remove the screw that secures the ground wire to the PSU.
b Move the wire away from the PSU.
5 Push the latching tab to the left as you pull outward on the handle to disengage the PSU internal
connectors (see Figure
Figure 173: Removing a DC PSU
Summit Family Switches Hardware Installation Guide
173).
SH_113
205