Installing An Eps-C Chassis - Extreme Networks Summit X150 Series Hardware Installation Manual

Installing Summit External Power Supplies

Installing an EPS-C Chassis

CAUTION
Do not use the rack mount brackets to suspend the EPS-C from under a table top or desk, or to attach the EPS-C
unit to a wall.
The EPS-C is intended for use only with a Summit X450e-48p or X250e-48p switch. You can install the
EPS-C above or below the Summit switch (see
Figure 161: EPS-C and Summit Switch
Stack 10G 1 2
1 1
2 2
MGMT
FAN STACK NO.
PSU-1
PSU-E
To rack-mount the EPS-C:
1 Place the EPS-C upright on a secure work surface.
2 Remove the mounting bracket kit from the packaging.
3 Attach the mounting brackets as follows:
a Place a rack mount bracket over the mounting holes on one side of the unit.
b Insert the provided screws and fully tighten them using a screwdriver (see
Figure 162: Attaching the Mounting Bracket
190
EPS-C
4 6 8 10 12 14 16 18 20 21 22
3 5 7 9 11 13 15 17 19 23
Summit X450e-48p Switch
Figure 161).
ESP-C
24 26 28 29 30 32 34 35 36 37 38 40 42 43 44
25 27 31 33 39 41
EPS-C
C
S -
E P
Rack Mount Bracket
PSU1 PSU2 PSU3
DC good
AC good
45 46 48 45X 46X 47X 48X Solid ON = Link
47
Blinking = Activity
Shared Ports
ESP-C_02
Figure
EPS-C_01
Summit Family Switches Hardware Installation Guide
162).