Table of Contents
Advertisement
Updating the server configuration
Use this information to update the server configuration.
When you start the server for the first time after you add or remove a device, you might receive a message
that the configuration has changed. The Setup utility starts automatically so that you can save the new
configuration settings.
Some optional devices have device drivers that you must install. For information about installing device
drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a hard disk drive, see the
documentation that comes with the RAID adapter for information about reconfiguring the disk arrays.
The server comes with at least one microprocessor. If more that one microprocessor is installed, the server
can operate as a symmetric multiprocessing (SMP) server. You might have to upgrade the operating system
to support SMP. For more information, see "Typical operating-system installation" on page 94 and the
operating-system documentation.
For information about configuring the integrated Gigabit Ethernet controller, see "Configuring the Gigabit
Ethernet controller" on page 106.
90
System x3300 M4 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
