Updating The Server Configuration - Lenovo System x3500 M5 Type 5464 Installation And Service Manual

USB connectors
Power supply 1
Power supply 2
Figure 93. Rear of server
Step 1. You must turn off the server before you connect or disconnect cables.
Step 2. See the documentation that comes with any external devices for additional cabling instructions. It
might be easier for you to route cables before you connect the devices to the server.

Updating the server configuration

Use this information to update the server configuration.
When you start the server for the first time after you add or remove a device, you might receive a message
that the configuration has changed. The Setup utility starts automatically so that you can save the new
configuration settings.
Some optional devices have device drivers that you must install. For information about installing device
drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a hard disk drive, see the
documentation that comes with the RAID adapter for information about reconfiguring the disk arrays.
For information about configuring the Ethernet controller, see "Configuring the Ethernet controller" on
page 116.
102
System x3500 M5 Installation and Service Guide
PCI slot 1
PCI slot 2
PCI slot 3
PCI slot 4
Ethernet 1
Ethernet 2
Ethernet 3
Ethernet 4
System-management
/ Ethernet (dedicated)
NMI button
Video
PCI slot 5
PCI slot 6
PCI slot 7