Remote Pim Over Ip - NEC NEAX 2000 IPS Reference Manual

Chapter 13 Voice Over IP (VoIP)
Service Conditions
1. IP-PAD and VCT are required for facsimile use on Peer-to-Peer CCIS network or Remote PIM over
IP function.
2. PN-32IPLA (IP-PAD) card and PN-16VCTA (16VCT) card do not support FAX and Modem over IP.
3. IP-PAD card and 16VCT card support Fax and Modem over IP with the following FAX protocol.
Cards
SPN-8IPLA IP PAD-B
SPN-8IPLA IP PAD-A
SPN-32IPLA IP PAD-E
SPN-32IPLA IP PAD-E +
SPN-16VCTAA IP PAD-B
SPN-32IPLA IP PAD-E +
SPN-16VCTAA IP PAD-A
SPN-32IPLA IP PAD-C +
SPN-16VCTAA IP PAD-A
X: Available —: Not available
4. The analog Media Converter used by 2400 IPX cannot be accommodated in 2000 IPS. It is possible
to connect facsimiles between 2400 IPX and 2000 IPS.
5. A problem may occur such as "expected transmission speed is not obtained" or "not connectable",
depending on a facsimile model even if it supports T.30.
6. If a Super G3 facsimile is used, the transmission speed will be equivalent to G3.
7. If a facsimile with Error Correction Mode (ECM) function is used, ECM does not work.
8. Connection speed for Modem over IP are:
a. G.711 Pass-through 24kbps – 14kbps
b. G726 Pass-though 14.4kbps – 9.6kbps
Page 13- 22
G.711
Pass-Through
X
(Series 3300 (Series 3300
software or later)
X
(Series 3300
software or later)
X
(Series 3400
software or later)
X
(Series 3300 (Series 3400
software or later)
—
—
NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
Protocol
G.726
Pass-through
X
software or later)
—
—
X
(Series 3200
software or later) software or later)
—
(Series 3200
software or later)
—
(Series 3200
software or later)
T.30
—
—
—
X
X
X
NDA-24349, Issue 4