NEC NEAX 2000 IPS Reference Manual page 188

Chapter 9 Feature Descriptions
Station Message Detail Recording (SMDR
This feature provides a call record for
outgoing station-to-trunk calls, incoming trunk-
to-station calls (including Data Call) and
tandem calls. This facilitates cost control by
identifying trunk use and misuse by individual
stations. Station Message Detail Recording
(SMDR) enables call billing to customers and
clients, and provides a means for checking
local telephone bills.
Station Speed Dialing
This feature allows a station user to dial
frequently called numbers by dialing an
access code and an abbreviated code, or by
depressing a feature key or line key assigned
for Station Speed Dialing capability.
Step Call
This feature allows the Attendant or station
user, after calling a busy station, to call an idle
station by simply dialing an additional digit.
This feature will operate only if the number of
the idle station is identical to that of the busy
station in all respects, except the last digit.
Supervisory Control of Peripheral
Equipment
When various types of peripheral equipment
(such as facsimiles, dictation equipment,
Voice Mail, etc.) are connected to the line
circuits of the NEAX2000 IPS, this feature
allows the loop of the line circuit concerned to
open for a programmable interval, and send a
release signal to the peripheral equipment
when the calling party disconnects.
System Clock Setup by Station Dialing
This feature enables a station user to set up
the system clock, from Single Line Telephone,
Multiline Terminal, and PS.
Page 9- 30
System Speed Dialing
)
This feature provides all users the ability to
dial frequently called numbers using an
abbreviated call code.
System Traffic
The NEAX2000 IPS is the stored program
controlled digital electronic PABX employing
PCM time division switching technique. Single
stage time division switching is employed for
all configurations of NEAX2000 IPS up to its
maximum line and trunk configuration. Traffic
capacity is expressed in Busy Hour Call
Attempts (BHCA). This value is the number of
call attempts that can be generated in the
busiest hour of the day.
Tenant Service
This feature provides for more than one
organization (tenant) to share the same
NEAX2000 IPS system. Through system
programming, each organization may be
restricted to its own Central Office trunks,
Attendant Consoles and extension group. In
addition, incoming calls are directed to the
specific tenant.
Tie Lines
This feature allows any station user dial
access or direct access to an E&M Tie Line.
Tie Line Tandem Switching
This feature allows trunk-to-trunk connections
through the NEAX2000 IPS without the need
for any Attendant assistance or control. The
major use of this feature is in association with
a dial tandem tie line network to allow tie line
connections and incoming tie line calls
automatic access to, and completion of, local
Central Office calls.
NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
NDA-24349, Issue 4