NEC NEAX 2000 IPS Reference Manual page 216

Chapter 10 System Input/Output (I/O) Interfaces
Service Conditions (con't)
When the Message Waiting lamp control is activated with the MCI, the lamp control from the
following equipment will not be provided:
From the Property Management System (PMS)
From the station (by dialing the access code)
From the Direct Station Selection (DSS) Console
From the Hotel/Motel Attendant Console
From the Hotel/Motel Front Desk Instrument
From the Attendant Console
Only one system should be programmed (via system programming) to control Message Waiting
lamps through the CCIS network.
The system controls Message Waiting lamps normally when the time interval between messages is
a minimum of 350 msec. or more.
When the VMS interface line does not answer, all of the messages are sent out from the I/O port of
the MP/AP00.
If the VMS is not ready for information receiving (Busy Status), the AP00 can temporarily store up to
16 call records in its internal memory. If the maximum of 16 call records is stored and a 17th is
generated, the system will write over the oldest stored record. When the RS port on the MP card is
used for the data link to the VMS, the MP can store up to 15 call records. If a 16th call record is
generated when the MP stores 15 call records, the system will write over the oldest stored record.
The Voice Mail Integration (Inband) feature can be combined with voice mail through the MCI in the
system. The Voice Mail Integration (Inband) feature and MCI feature can coexist in one system and
either can be selected per VMS (VMS station number) by system programming.
When terminating a call with the ANI information to the VMS through the MCI, the system can send
the ANI information to the VMS, if required. This is not available through CCIS interface.
Hardware Required for MCI
Description
SPN-CP24A MP (UA)
SPN-AP00B MRC-C (AP)
RS RVS-4S CA-C
RS NORM-4S CA-A
AP VM-0.7 CA-A
PN-8LCAA
VMS
MODEM
Page 10-8
Qty Remarks
1 per system MP
1 per system Control card for MCI
1 per VMS AP00-VMS, 13.1ft (4.0m)
1 per VMS AP00-MODEM, 13.1ft (4.0m)
1 per AD8 AP00-VM00 (AD8), 2.3ft (0.7m)
As required Interface for VMS (with MW lamps)
1 per system
As required
NEAX 2000 IPS Request for Proposal (RFP) Reference Guide
NDA-24349, Issue 4