Phone Display Options - Altigen AltiWare OE Version 4.6 Administration Manual

Configure the following hardware extension-specific features:
Parameter
Message Waiting
Signal Type
Caller ID Signal
Format
Line Disconnect
Signal
Ringing Frequency
Receiver Gain/
Transmission
Attenuation
Caution: If the Receiver Gain or the Transmission Attenuation
setting is too high, the result will be distortion in voice
quality.

Phone Display Options

For analog and IP phones, the administrator can select what information is
to be displayed. Depending on the number of display lines on the LCD, the
phone can be set up to show two lines of specific caller information on the
display.
In the Phone Display field, use the Number Line and Name Line drop-
down lists to select the caller information to display:
• Caller Number
• Caller Name
• DNIS Number
• DNIS Name
• IVR Data
AltiWare OE System Installation & Administration Manual
Extension and Group Configuration
Description
FSK or None.
SDMF, MDMF, or None.
The loop break desired for answering
supervision, either 200 or 600 ms.
Note: If the extension uses a 390 phone with
Intercom service, set this to 750 ms.
Select the frequency in Hz that is necessary for
the equipment attached to this line.
Incoming and outgoing volume for every
extension. Unlike the Quantum board, these
slide settings have positive and negative values.
Both defaults are 0 decibels.
8-19