Ip Extension Configuration; Phone Display Options - Altigen AltiWare ACM 5.1 Administration Manual

Chapter 15: Extension Configuration
Parameter
Ringing Frequency
(Hz)
Line Disconnect
Signal
Caller ID
Transmission
Methods
Receive from phone
(dB Gain)
Transmit to phone
(dB Gain)

IP Extension Configuration

See "Setting Up IP Extensions" on page 225 for information on configuring this section
of the Extension Configuration General tab.

Phone Display Options

For analog and IP phones, the administrator can select what information is to be
displayed.
Depending on the number of display lines on the LCD, the phone can be set up to show
two lines of specific caller information on the display.
In the Phone Display field, use the Number Line and Name Line drop-down lists to
select the caller information to display:
Caller Number
•
Caller Name
•
DNIS Number
•
DNIS Name
•
IVR Data
•
User Data
•
202
AltiWare ACM 5.1 Administration Manual
Description
Select the frequency in Hz that is necessary for the
equipment attached to this line: 28 (default) or 20.
The loop current break desired for answering
supervision. Range 600-1000 ms (1000 ms is
default).
Specifies how Caller ID will be detected:
• CID between 1st and 2nd ring - Caller ID is
received between first and second ring. (Most
common in US/Canada)
• DT-AS+CID prior to ringing - Dual Tone Alerting
Signal Caller ID is received prior to ringing.
• RP-AS+CID prior to ringing - Ring Pulse Alerting
Signal Caller ID is received prior to ringing.
Range -3 ~ +3 db
You can decrease or increase the extension phone's
talk volume with this setting. Default is 0 dB.
Range -3 ~ +3db
You can decrease or increase the extension phone's
receiving volume with this setting. The volume will
be lower or higher for the extension user. Default is
0 dB.