Table of Contents
Advertisement
Parameter
Board Configuration
Reset Board
Configuring the Triton VoIP Board
Voice over IP for AltiWare OE
VoIP for AltiWare OE runs on an H.323 platform that allows voice calls to
be made through an IP network. It includes an integrated VoIP gateway to
convert voice calls into IP packets and transmit them through the IP
network. It also has the capability of networking multiple AltiServs into a
virtual PBX network. This enables calls to be made through the IP network,
which allows for significant savings in toll charges.
Triton VoIP Board
The Triton VoIP board is used to provide voice processing resources for
AltiWare OE, similar to the way Quantum telephony boards are used for
analog trunks and extension lines. Unlike the Quantum telephony boards,
however, only IP trunks are provided on the Triton VoIP board. AltiWare
VoIP uses DSP engines residing on the Triton VoIP board to perform the
voice processing functions needed for H.323 devices. Quantum and Triton
boards are connected via MVIP connectors.
The Triton VoIP board is available as a 12-port and 30-port board.
Important: Triton 30-port VoIP boards are recommended for use with IP
extensions only or for tie-trunk configurations to other 30-port
VoIP boards. Additionally, to prevent users from directly
accessing the 30-port boards—which use the G.711 codec
only—for calls to AltiWare servers or other IP gateways that
may require the G.723 codec, it is recommended that the trunk
access code is set to "None" for trunks on 30-port IP boards.
(See "Setting General Trunk Attributes" on page 7-3 for more
AltiWare OE System Installation & Administration Manual
Description
Displays the board's serial number.
Resets the board, after you confirm resetting by
accepting a warning.
Important:
Resetting a board will disconnect all
calls in progress on that board! Be sure
to inform all users before resetting a
board.
Board Configuration
6-7
Advertisement
Table of Contents
Troubleshooting
