Altigen AltiWare OE Version 4.6 Administration Manual page 434

Call Router Advanced
Note:
The workgroup to which incoming trunk calls will be routed via
Call Router must be assigned to the Auto Attendant whose Action
is set to "Avd - Data Directed Routing, with Application set to the
virtual extension you use to start Call Router. For further
information on configuring Auto Attendants, refer to the AltiWare
"Auto Attendant Configuration" on page 10-1 and the AltiAPI
Programmer Guide.
To Install Call Router Advanced:
Run Call Router, select the Call Router Advanced and click Next. When
prompted, enter the 20 digit license key for Call Router Advanced in the
field and click Next. Setup will confirm the destination for the Call Router
application (default is C:\Program Files\AltiGen\Call Router). Click Next
to proceed. To select a different location, use the Browse button to choose
the new destination.
Note:
Call Router Advanced Service requires the purchase and
activation of the Advance Call Router license.
To Configure/Run Call Router Advanced:
1. Launch Call Router from Start>Programs.
2. Click the Connect button to enter the Call Router Server Name or IP
address to connect to, then click OK.
To disconnect from this server, click the Disconnect button.
20-10 AltiWare OE System Installation & Administration Manual