Board Configuration - Altigen AltiWare OE Version 4.6 Administration Manual

Configuring the Triton T1/PRI Board
• MEGACOMM
Framing:
• Super Frame (SF)/D4
• Extended Super Frame (ESF) (recommended)
Line Coding:
• Alternate Mark Inversion (AMI)
• B8ZS (recommended)
Physical Termination: RJ-48X or RJ-48C
Wire: 4 wires
PRI Channel Assignment
D Channels Assignment: 24th channel (channel ID 23)
Note: AltiServ can configure any channel in a PRI span to be the D
channel. The default setting is the last channel. Every span
should select a D channel within the span. OE 3.5A and higher
does not support shared D channel (NFAS) or back up D
channel.
Hunting: Most Idle, Least Idle, Ascend, Descend
DNIS Digits: can be 3 to 10 digits
CSU/DSU Requirements
The CSU (channel service unit) is a device used to connect a digital trunk
line coming in from the phone company to the PBX. A CSU can terminate
signals, repeat signals, and respond to loopback commands sent from the
central office.

Board Configuration

Double click the board's icon in the Boards window (see Figure 1) to open
the Board Configuration window.
6-32 AltiWare OE System Installation & Administration Manual