1. Remove any adapter cards that are connected to the extender board (see
2. Remove the two screws that attach the extender board to the chassis.
3. Pull the extender board in the direction of the system feet until it detaches from
Power/LED switch
To remove the power/LED switch, do the following:
1. Power-off the computer and remove external cables.
2. Remove the cover and support bracket (see "Side cover removal" on page 63
3. Remove the bezel, remove the front bezel (see "Bezel" on page 94).
98
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
"Adapter installation" on page 66).
the system board; then pull it out of the computer.
Note: Read "Before you begin" on page 41 and the safety notices at "Safety notices
(multi-lingual translations)" on page 135.
and "Support bracket removal" on page 64).