Handle Cap - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

4. Use side cutters to sever the fan's four rubber extensions on the outside of the
5. Pull the fan away from the chassis.
6. To install the rear fan, reverse the previous steps.

Handle cap

Note: This illustration is for reference only; your hardware may differ.
To remove the handle cap, do the following:
1. Power-off the workstation, if it is on.
2. Unplug the workstation.
3. Use a flathead screwdriver to gently press in and down on the tabs located on
4. Lift up on the handle cap to separate it from the handle support.
96
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
chassis.
Note: After guiding the four rubber extensions through the apertures on the
chassis, use needle-nosed pliers to pull the extensions firmly through.
Note: Read "Before you begin" on page 41 and the safety notices at "Safety notices
(multi-lingual translations)" on page 135.
the interior side wall of the handle.