IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual page 75

Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see "Handling
electrostatic discharge-sensitive devices" on page 134.
1. Review the information in "Safety information" on page 131.
2. Turn off the computer and all attached devices.
3. Disconnect all external cables and power cords; then remove the side cover.
See "Side cover removal" on page 63.
4. Determine which PCI slot you will use for the adapter.
Note: Check the instructions that come with the adapter for any requirements,
restrictions, or cabling instructions. It might be easier to route any
cables before you install the adapter.
5. For full-length adapters, rotate the rear adapter retention bracket to the open
(unlocked) position and remove it from the computer. Rotate the front adapter
retention bracket to the open position. If you are installing a smaller adapter,
remove only the rear retention bracket.
6. Remove the expansion-slot cover. From the rear of the computer, press on the
slot cover. Grasp it and pull it out of the expansion slot. Store it in a safe place
for future use.
Attention: Expansion-slot covers must be installed on all vacant slots. This
maintains the electronic emissions standards of the computer and ensures
proper ventilation of computer components.
7. Set any jumpers or switches on the adapter or system board as described by
the adapter manufacturer.
8. Remove the adapter from the static-protective package, and carefully grasp
the adapter by the top edge or upper corners, and align it with the expansion
slot guides; then press the adapter firmly into place.
67
Installing options