Replacing The Cover; Connecting External Options - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

Replacing the cover

Do the following to replace the cover of the tower model:
Note: If you removed the support bracket, reinstall it before you replace the cover.
1. Clear any cables that might impede the replacement of the cover.
2. Install the side cover by placing it into position on the computer. Be certain the
3. If you have not done so already, make sure that the two front stabilizing feet
4. Reconnect the external cables and power cords to the computer; then connect
5. Turn on the attached devices; then turn on the computer.

Connecting external options

You can connect a number of optional external devices to the connectors on the
rear and front of the computer. If the computer comes with a SCSI adapter
installed, you can attach a SCSI storage expansion enclosure to the computer.
To attach an external device:
1. Read "Before you begin" on page 41, review the safety precautions listed in
2. Be sure that the computer and all attached devices are turned off.
3. Follow the instructions that come with the option to prepare it for installation
See "Support bracket removal" on page 64 for details.
notches on the underside of the cover match up to the holes along the sides of
the computer. Press down on the cover release latch button as you close the
cover release latch to lock the cover.
are rotated outward so that they properly support the computer. Rotate each
individual foot outward 90 degrees.
the power cords to electrical outlets.
Statement 1 and Statement 5 in "Safety notices (multi-lingual translations)" on
page 135, and read the documentation that comes with the options.
and to connect it to the computer.
77
Installing options