3. Disconnect all adapter cards from the system board and remove them from the
4. Pull the adapter retainer away from the chassis.
5. To install the adapter retainer, reverse the previous steps.
Bezel
To remove the main bezel on the tower model, do the following:
1. Remove the side cover (see "Side cover removal" on page 63).
2. Push the blue bezel release latch, located on the inside roof of the tower
3. To install the bezel, align the tabs at the bottom of the bezel with the slots in
Bezel release latch
94
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
computer (see "Adapter installation" on page 66).
chassis. The bezel will detach from the chassis.
the lower front of the chassis; then press the top of the bezel against the chassis
until it clicks into place.
Note: Read "Before you begin" on page 41 and the safety notices at "Safety notices
(multi-lingual translations)" on page 135.