Bay 5, 6 Or 7 Installation - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

11. If the drive is an IDE device, connect one end of the IDE signal cable into the
12. Connect the power cable to the back of the drive. The connectors are keyed
13. If you have other options to install or remove, do so now.
14. Replace the support bracket.
15. Replace the side cover, see "Replacing the cover" on page 77 for details.
16. Reconnect the external cables and power cords; then turn on the attached
Bay 5, 6 or 7 installation: Bays 5, 6, and 7 are in the drive cage. The drive cage is
located just above the front adapter-support bracket.
Note: You might find it useful to work with the computer laying on its side.
To install a drive in bay 5, 6, or 7, do the following:
72
Hardware Maintenance Manual: IBM IntelliStation E Pro Type 6204 and Type 6214
Note: You can install only a 3.5-in. device in bay 4.
back of the drive and the other end of the cable into the IDE connector on the
system board. For the location of the IDE connectors, see "System board
internal cable connectors" on page 44. If the drive is a SCSI device, connect
one end of the SCSI signal cable into the back of the drive and the other end
of the cable into the 68-pin connector on the SCSI adapter.
Note: Route the signal cable so that it does not block the air flow to the rear
of the drives or over the microprocessor.
and can be inserted only one way.
devices and the computer.
1. Read the information in "Preinstallation steps" on page 70.
2. Turn off the computer and all attached devices. Disconnect all external cables
and power cords; then remove the cover. See "Side cover removal" on page 63
for details.