IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual page 123

Error Code/Symptom
179 (Boot integrity services
segment error)
184 (Power-on password
corrupted)
185 (Drive startup sequence
information corrupted)
186 (Security hardware
control logic failed)
187 (VPD serial number not
set.)
188 (Bad EEPROM CRC #2)
189 (Three attempts were
made to access the
workstation with invalid
passwords)
190 (Invalid remote change
requested)
191 (IBM embedded security
hardware reset)
193 (IBM embedded security
hardware removed)
195 (Asset ID antenna has
been installed)
196 (System tampered
cleared)
201 (Memory test error, see
"IBM Setup Utility main
menu choices" on page 32.) If
the workstation does not
have the latest level of BIOS
installed, update the BIOS to
the latest level and run the
diagnostic program again.
229 (Cache error)
289 (DIMM has been disabled
by user or system, see "IBM
Setup Utility main menu
choices" on page 32.)
301 (Keyboard or keyboard
controller error)
303 (Keyboard controller
error)
FRU/Action
1. Flash BIOS
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Set serial number in Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup, enter the administrator password
2. System Board.
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run Configuration/Setup
2. System Board
1. Run memory diagnostics
2. DIMM
3. System Board
1. Microprocessor
1. Run Configuration/Setup, if disabled by user
2. Disabled DIMM, if not disabled by user.
1. Keyboard
2. System Board
1. System Board
2. Keyboard
115
Symptom-to-FRU index