Adapter Guide; Adapter Retainer - IBM 621410U - IntelliStation E - Pro 6214 Hardware Maintenance Manual

4. Press the two fan retention latches until the fan pops free and gently pull the
fan out of the adapter guide, making sure the cable comes free smoothly.
5. To install the adapter fan, reverse the previous steps.
Note: Guide the fan cable through the cutout in the adapter guide before
inserting the fan.

Adapter guide

To remove the adapter guide, do the following:
Note: Read "Before you begin" on page 41 and the safety notices at "Safety notices
(multi-lingual translations)" on page 135.
1. Power-off the computer and remove external cables.
2. Remove the cover and support bracket (see "Side cover removal" on page 63
and "Support bracket removal" on page 64).
3. Remove the front bezel (see "Bezel" on page 94).
4. Disconnect all adapter cards from the system board and remove them from the
computer (see "Adapter installation" on page 66).
5. Push inward on the two tabs on the left and push them toward the inside of
the computer until they clear the notches; then, the three tabs on the right will
come away from the chassis.
6. Pull the adapter guide away from the chassis.
7. To install the adapter guide, reverse the previous steps.
Note: When installing a new adapter guide, be sure to transfer any existing
adapter fan (see "Adapter fan" on page 92); not all models are
configured with this fan.

Adapter retainer

To remove the adapter retainer, do the following:
Note: Read "Before you begin" on page 41 and the safety notices at "Safety notices
(multi-lingual translations)" on page 135.
1. Power-off the computer and remove external cables.
2. Remove the cover and support bracket (see "Side cover removal" on page 63
and "Support bracket removal" on page 64).
FRU information (service only)
93