Table of Contents
Advertisement
No Beep Symptom
No Beeps occur after
successfully completing
POST
No ac power
No beep and no video
Diagnostic error codes
Note: In the following error codes, if XXX is 000, 195, or 197, do not replace a
Error Code/Symptom
001-XXX-000 (Failed core
tests)
001-XXX-001
(Failed core tests)
001-250-000
(Failed System Board ECC)
001-250-001
(Failed System Board ECC)
005-XXX-000
(Failed Video test)
011-XXX-000
(Failed COM1 Serial Port
test)
011-XXX-001
(Failed COM2 Serial Port
test)
014-XXX-000
(Failed Parallel Port test)
015-XXX-001
(USB interface not found,
board damaged)
FRU/Action
1. Check speaker connections
2. Speaker
3. System board
1. Check the power cord.
2. Power supply.
1. See "Undetermined problems" on page 119
FRU. The description for these error codes are:
000
The test passed.
195
The Esc key was pressed to abort the test.
197
This is a warning error and may not indicate a hardware failure.
For all error codes, replace/follow the FRU/Action indicated.
FRU/Action
1. System Board
1. System Board
1. System Board
1. System Board
1. Video Adapter (if installed)
2. System Board
1. System Board
1. System Board
1. System Board
1. System Board
109
Symptom-to-FRU index
Advertisement
Chapters
Table of Contents
Troubleshooting
