Paper Feed Section; Detaching And Refitting The Forwarding, Upper Paper Feed And Lower Paper Feed Pulleys; Detaching And Refitting The Pulleys Of Drawers 1, 2, And 3 - Kyocera Mita KM-4530 Service Manual

1-6-2 Paper feed section

(1) Detaching and refitting the forwarding, upper paper feed and lower paper feed pulleys

Follow the procedure below to clean or replace the forwarding, upper and lower paper feed pulleys.

(1-1) Detaching and refitting the pulleys of drawers 1, 2, and 3

Procedure
• Removing the primary paper feed unit
1. Remove the screw holding the developing
duct cover and disconnect the connector, and
then remove the cover.
2. Remove the six screws holding the middle
right cover and then the cover.
3. Lift the right cover and remove it from the
main unit of the machine.
Connector
Developing duct cover
Figure 1-6-1
Middle right cover
Figure 1-6-2
Right cover
Figure 1-6-3
2BC/D
1-6-3