Back To Factory Defaults; Restart Screen; Figure 132 Configuration Upload Error; Figure 133 Reset Warning Message - ZyXEL Communications ZyWall P1 User Manual
Hide thumbs
Also See for ZyWall P1:
- Quick start manual (72 pages) ,
- Quick start manual (64 pages) ,
- User manual (490 pages)
Table of Contents
Advertisement
ZyWALL P1 User's Guide
Figure 132 Configuration Upload Error
16.6.3 Back to Factory Defaults
Pressing the Reset button in this section clears all user-entered configuration information and
returns the ZyWALL to its factory defaults as shown on the screen. The following warning
screen will appear.
Figure 133 Reset Warning Message
You can also press the RESET button on the rear panel to reset the factory defaults of your
ZyWALL. Refer to
16.7 Restart Screen
System restart allows you to reboot the ZyWALL without turning the power off.
Click MAINTENANCE, and then Restart. Click Restart to have the ZyWALL reboot. This
does not affect the ZyWALL's configuration.
246
Section 2.3 on page 41
for more information on the RESET button.
Chapter 16 Maintenance
Advertisement
Table of Contents
Troubleshooting
