Removing The Intel Raid C600 Upgrade Key; Installing And Removing The Intel Remote Management Module 4; Installing The Intel Rmm4 Lite; Install The Intel Rmm4 Nic - Intel R1000EP Series Service Manual

Server System Features
Removing the Intel
Pull up the key to remove it from the mother board.
Installing and Removing the Intel
Module 4
Installing the Intel
Locate the RMM4 Lite connector next to Riser Slot 1, carefully pick up the Intel
module, match the alignment pin of the module and the connector on server board, then press
to install.
®
Install the Intel
1. Push out and remove the metal cover on the chassis where the NIC RJ-45 receptacle will align
(see letter A).
2. Insert and fit the metal adapter into the position shown below. Secure the adapter with two
screws as shown (see letter B).
3. Position the module over the server board, fit the front of the module into the back panel slot,
then attach the module to the server board connector Secure the module with the one screw as
shown (see letter C).
34
®
RAID C600 Upgrade Key
®
RMM4 Lite
Figure 54. Installing the Intel
RMM4 NIC
®
Remote Management
®
RMM4 Lite
®
Intel Server System R1000EP Service Guide
®
RMM4 Lite