Set Igmp Maxresponse; Set Igmp Mcrtrexpiretime - NETGEAR ProSafe GSM7228PS Cli Manual

set igmp maxresponse

This command sets the IGMP Maximum Response time for the system, or on a particular interface
or VLAN. The Maximum Response time is the amount of time in seconds that a switch will wait
after sending a query on an interface because it did not receive a report for a particular group in
that interface. This value must be less than the IGMP Query Interval time value. The range is 1 to
25 seconds.
Default 10 seconds
Format
set igmp maxresponse <1-25>
Mode • Global Config
• Interface Config
Format
set igmp maxresponse <vlan_id> <1-25>
Mode VLAN Config
no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
Format
no set igmp maxresponse
Mode • Global Config
• Interface Config
Format
no set igmp maxresponse <vlan_id>
Mode VLAN Config

set igmp mcrtrexpiretime

This command sets the Multicast Router Present Expiration time. The time is set for the system, on
a particular interface or VLAN. This is the amount of time in seconds that a switch waits for a
query to be received on an interface before the interface is removed from the list of interfaces with
multicast routers attached. The range is 0 to 3600 seconds. A value of 0 indicates an infinite time-
out, i.e. no expiration.
Default 0
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-142