Ip Arp Inspection Filter - NETGEAR ProSafe GSM7228PS Cli Manual

Default
15 pps for rate and 1 second for burst-interval
Format
ip arp inspection limit {rate pps [burst interval seconds] | none}
Mode Interface Config
no ip arp inspection limit
Use this command to set the rate limit and burst interval values for an interface to the default
values of 15 pps and 1 second, respectively.
Format
no ip arp inspection limit
Mode Interface Config

ip arp inspection filter

Use this command to configure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges. If the static keyword is given, packets that do not match a permit
statement are dropped without consulting the DHCP snooping bindings.
Default
No ARP ACL is configured on a VLAN
Format
ip arp inspection filter acl-name vlan vlan-list [static]
Mode Global Config
no ip arp inspection filter
Use this command to unconfigure the ARP ACL used to filter invalid ARP packets on a list of
comma-separated VLAN ranges.
Format
no ip arp inspection filter acl-name vlan vlan-list [static]
Mode Global Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-133