NETGEAR ProSafe GSM7228PS Cli Manual page 153

• Multicast MAC and source ports and destination ports (max=20)
Format
macfilter <macaddr> <vlanid>
Mode Global Config
no macfilter
This command removes all filtering restrictions and the static MAC filter entry for the MAC
address <macaddr> on the VLAN <vlanid>. The <macaddr> parameter must be specified
as a 6-byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
no macfilter <macaddr> <vlanid>
Mode Global Config
macfilter adddest
Use this command to add the interface to the destination filter set for the MAC filter with the given
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-
byte hexadecimal number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must
identify a valid VLAN.
Note: Configuring a destination port list is only valid for multicast MAC addresses.
Format
macfilter adddest <macaddr> <vlanid>
Mode Interface Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-115