Lacp Partner Port Priority - NETGEAR ProSafe GSM7228PS Cli Manual

no lacp partner port id
Use this command to set the LACP partner port id to the default.
Format
no lacp partner portid
Mode Interface Config

lacp partner port priority

Use this command to configure the LACP partner port priority. The valid range for <priority>
is 0 to 255.
Default 0x0
Format
lacp partner port priority <priority>
Mode Interface Config
Note: This command is only applicable to physical interfaces.
no lacp partner port priority
Use this command to configure the default LACP partner port priority.
Format
no lacp partner port priority
Mode Interface Config
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-100