Radius Accounting Mode; Radius Server Attribute - NETGEAR ProSafe GSM7228PS Cli Manual

radius accounting mode

This command is used to enable the RADIUS accounting function.
Default disabled
Format
radius accounting mode
Mode Global Config
no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the
RADIUS accounting function is disabled.
Format
no radius accounting mode
Mode Global Config

radius server attribute

This command specifies the RADIUS client to use the NAS-IP Address attribute in the RADIUS
requests. If the specific IP address is configured while enabling this attribute, the RADIUS client
uses that IP address while sending NAS-IP-Address attribute in RADIUS communication.
Format
radius server attribute <4> [<ipaddr>]
Mode Global Config
Term Definition
4 NAS-IP-Address attribute to be used in RADIUS requests.
ipaddr The IP address of the server.
no radius server attribute
The version of this command disables the NAS-IP-Address attribute global parameter for
no
RADIUS client. When this parameter is disabled, the RADIUS client does not send the NAS-IP-
Address attribute in RADIUS requests.
Management Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
8-53