Poe High-Power - NETGEAR ProSafe GSM7228PS Cli Manual

no poe detection
This command sets the detection mode to default on a global basis or per interface.
Format
no poe detection
Mode Global Config
Interface Config

poe high-power

This command switches a port from 802.3af mode to High Powere mode. This mode is used to
power up devices that require more power than the current IEEE 802.3af power (more than 12.95
Watts at the PD). When switching to High Power mode, make sure that the device is a Class 4
device.
Three options are available:
- use this mode if the device can power up (more than 12.95 Watts) with higher current
legacy
and it cannot identify itself as Class 4 device.
Note: Only ports 1-8 support this high power.
- Use this mode if the device cannot identify itself as Class 4 device and it does not
pre-dot3at
have LLDP support.
- Use this mode if the device is a Class 4 device capable of figuring out power
dot3at
requirement through LLDP.
Format
poe high-power {legacy | pre-dot3at | dot3at}
Mode Interface Config
Default Disable
no poe high-power
This command disables the High Power mode. The port will only support IEEE 902.3af devices.
This command works on a global basis or per interface.
Format
no poe high-power
Mode Interface Config
Power Over Ethernet Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
5-4