Walkthrough: Looking At The Job After It Has Run; Verification At The Command Line - Novell PLATESPIN ORCHESTRATE 2.0.2 - INSTALLATION AND CONFIGURATION GUIDE 10-09-2009 Installation And Configuration Manual

3.8 Walkthrough: Looking at the Job After It Has
Run
After you have run the job, there are several ways to verify that it has run. This section explains
those methods.
Section 3.8.1, "Verification at the Command Line," on page 118
Section 3.8.2, "Verification at the Jobs Monitor," on page 119
Section 3.8.3, "Verification at the Server Portal," on page 120

3.8.1 Verification at the Command Line

The following sections explain some of the
run and monitor some of the results of the job:
"zos jobs" on page 118
"zos jobinfo job_name" on page 118
"zos status --detail" on page 118
"zos log job_id --verbose" on page 119
zos jobs
You can use the
in as a user. Running this command yields an output like this:
Job
whoami
Completed
zos jobinfo job_name
You can use the
last time it was run. Running this command yields an output like this:
Jobname/Parameters
------------------
whoami
numJoblets
resource
zos status --detail
You can use the
Running this command yields an output like this:
118 PlateSpin Orchestrate 2.0 Installation and Configuration Guide
command to list all of the jobs that have run while you have been logged
zos jobs
JobID User
userA.whoami.60 userA
zos jobinfo -e job_name
Attributes
----------
Desc: This is a demo example of enhanced exec
Desc: The number of joblets to schedule
Type: Integer
Default: 1
Desc: The resource id to run on
Type: String
Default: .*
zos status --detail
commands that you can use to verify that a job has
zos
Started
12/24/2008 02:35:38
command to display information for a named job the
command to display the status of the most recently run job.
Elapsed State
0:00:00