Novell PLATESPIN ORCHESTRATE 2.0.2 - INSTALLATION AND CONFIGURATION GUIDE 10-09-2009 Installation And Configuration Manual page 54

4f Select the PlateSpin Orchestrate installation patterns that you want to install:
Refer to the information in
Patterns," on page 125
4g Click OK to install the patterns.
You must install PlateSpin Orchestrate components before you can configure them.
5 Configure the PlateSpin Orchestrate components that you have installed. You can use one of
two methods to gather information for the configuration:
The PlateSpin Orchestrate product configuration script. If you use this method, continue
with
The GUI Configuration Wizard. If you use this method, skip to
NOTE: The remaining steps in this procedure show the installation of the Orchestrate Agent as
an example of component installation. Steps for installing any of the other components are
similar. Refer to
for further information you might need to configure a component.
6 (Conditional) If you use the PlateSpin Orchestrate product configuration script, run it from the
command line.
6a Make sure the product ISO is accessible. The script copies some files from the ISO.
6b Make sure you are logged in as
6c Run the script, as follows:
/opt/novell/zenworks/orch/bin/config
When the script runs, the following information is initially displayed:
Welcome to PlateSpin Orchestrate.
This program will configure PlateSpin Orchestrate 2.0
Select whether this is a new install or an upgrade
54 PlateSpin Orchestrate 2.0 Installation and Configuration Guide
Orchestrate Agent: Runs applications on all managed nodes under the management
of the Orchestrate Server. An agent reports its status to the Orchestrate Server.
Includes packages to help you configure the Orchestrate Agent.
Virtual Machine Builder: Installs software on the individual nodes where
customers want the VMs to be created from the VM Client.
Monitoring Agent: This pattern installs the Ganglia Agent (gmond) on each
monitored node, which collects performance metrics and sends the data to the
Orchestrate Monitoring Server. This pattern includes packages that help you
configure the Monitoring Agent.
If you select the Orchestrate Agent pattern, the Monitoring Agent pattern is selected
by default. This is only a recommended dependence (most users install both
components together) and is not binding. The autoselection is made for your
convenience.
For more information about gmond, see
the PlateSpin Orchestrate 2.0 Developer Guide and
Appendix A, "PlateSpin Orchestrate Components: Install
for details on the installation data that you need to know.
Step 6 on page 48.
Section 2.2.2, "PlateSpin Orchestrate Configuration Information," on page 30
"Understanding Resource Metrics
to run the configuration script.
root
Facts" in
Reference.
Step 7 on page 49.