Novell PLATESPIN ORCHESTRATE 2.0.2 - INSTALLATION AND CONFIGURATION GUIDE 10-09-2009 Installation And Configuration Manual page 66

12 Accept the remaining defaults in the setup wizard pages to run the Orchestrate Agent
installation until the following page is displayed:
13 Click Finish to exit the setup.
14 Register the agent to the PlateSpin Orchestrate Development Client. For more information on
how to register the agent, see
page 103.
Installing and Registering the PlateSpin Orchestrate Agent on an ESX Machine from
the Administrator Information Page
1 From the Administrator Information Web page for PlateSpin Orchestrate, download the
following:
novell-zenworks-zos-agent-2.0.2.rpm
The Java 1.5.0 (32-bit) or Java 1.5.0 (64-bit) RPM, depending upon the ESX processor on
which you want to install the Orchestrate Agent.
For more information on how to access the Administrator Information Web page, see
Section 2.3.2, "Installing the Orchestrate Agent from the Administrator Information Page," on
page 60.
2 Copy the downloaded
1.5.0 RPM to the ESX machine on which you want to install the Orchestrate Agent.
3 Install the Java 1.5.0 RPM by entering the following command:
rpm -ivh novell-zenworks-zos-java-1.5.0.rpm
4 Install the Orchestrate Agent by entering the following command:
rpm -ivh novell-zenworks-zos-agent-2.0.2rpm
5 Edit
/opt/novell/zenworks/zos/agent/agent.properties
zos.agent.server
register the agent.
6 At the Linux bash prompt, enter the following command to open TCP port 8100:
esxcfg-firewall -o 8100,tcp,out,port_name
7 Enter the following command to open TCP port 8101:
66 PlateSpin Orchestrate 2.0 Installation and Configuration Guide
Section 3.3, "Walkthrough: Creating a Resource Account," on
novell-zenworks-zos-agent-2.0.2.rpm
to the IP address of the PlateSpin Orchestrate Server to which you want to
and the appropriate Java
to set the value of