Novell PLATESPIN ORCHESTRATE 2.0.2 - INSTALLATION AND CONFIGURATION GUIDE 10-09-2009 Installation And Configuration Manual page 82

Workstations for Running the VM Client Software
The following table contains a list of operating system, hardware requirements, and installation file
paths for PlateSpin Orchestrate VM Client. The installed program execution file is found in the ISO
in the indicated folder.
Workstation Installation Constraints
Table 2-3
Operating System
Windows XP, Vista
SLES 10 SP2
SLES 11, SLED 11
NOTE: When you install the Xen kernel, make sure you install the
Xen VMs can be used on any 32-bit or 64-bit operating system.
Uninstallation of Previous Versions of the Client
You must uninstall the previous version of VM Client before installing version 2.0:
Windows: On the Windows machine where the client is installed, click Start > Control Panel >
Add or Remove Programs, select the Novell ZENworks VM Manager item, then click Remove.
Linux: Run the following command:
/opt/novell/zenworks/vmmanagement/Uninstall_ZENworks_VMM/
Uninstall_Novell_ZENworks_VM_Manager_1.3.0
This opens the InstallAnyWhere utility to uninstall VM Client.
82 PlateSpin Orchestrate 2.0 Installation and Configuration Guide
Recommended Hardware
i386 (32-bit) and 64-
bit
240 MB of free
space
i386 (32-bit) and 64-
bit
257 MB of free
space
i386 (32-bit) and 64-
bit
257 MB of free
space
Installation File
cdrom_drive\i386\Windows\vmclient_insta
ll.exe
or
cdrom_drive\x86_64\Windows\vmclient_ins
tall.exe
cdrom_drive/i386/SLE10/vmclient_install
or
cdrom_drive/x86_64/SLE10/
vmclient_install
cdrom_drive/sles11/i386/SLE11/
vmclient_install
or
cdrom_drive/sles11/x86_64/SLE11/
vmclient_install
kernel-xenpae
to ensure that