Other Orchestrate Clients - Novell PLATESPIN ORCHESTRATE 2.0.2 - INSTALLATION AND CONFIGURATION GUIDE 10-09-2009 Installation And Configuration Manual

1.1.6 Other Orchestrate Clients

You can monitor and run jobs, run the command line interfaces, and create and modify jobs by using
the tools and monitors included with the PlateSpin Orchestrate Clients. PlateSpin Orchestrate
manages jobs on and gathers data about data center computing resources that meet the following
minimum requirements:
Orchestrate Client Requirements
Table 1-5
Item
Operating System
Hardware
TCP Ports
IMPORTANT: The platforms listed here have been tested for the 2.0 release, and are the only
platforms supported at this time.
Some of the install programs for other operating systems that are embedded with the Administrator
Information page have not been tested for this release.
Requirement
Linux machines:
SUSE Linux Enterprise Server 10 SP2 (32-bit or 64-bit)
SUSE Linux Enterprise Server 11 (32-bit or 64-bit)
SUSE Linux Enterprise Desktop 11 (32-bit or 64 bit)
Windows machines:
Windows XP (32-bit or 64-bit)
Windows Vista* (32-bit or 64-bit)
The Orchestrate Development Client installation does not require a
minimum hardware configuration other than a minimum recommended
disk space of 100 MB and an SVGA-grade monitor.
The Orchestrate Clients consist of various components that communicate
with the Orchestrate Server:
Port 8100 is used with a custom protocol for invoking the zos
command line interface or for opening the SDK (Java Developer's
toolkit).
Port 8101 is also used for invoking the zos command line interface
or opening the Java Developer's toolkit by using TLS.
Port 1099 is used with RMI for invoking the zosadmin command line
interface or for running the Orchestrate Development Client.
Planning the Orchestrate Server Installation 15