Novell PLATESPIN ORCHESTRATE 2.0.2 - INSTALLATION AND CONFIGURATION GUIDE 10-09-2009 Installation And Configuration Manual page 24

5 Configure the PlateSpin Orchestrate components that you have installed. You can use one of
two methods to perform the configuration:
The PlateSpin Orchestrate product configuration script. If you use this method, continue
with
The GUI Configuration Wizard. If you use this method, skip to
TIP: The text-based configuration process detects which RPM patterns are installed, but the
GUI Configuration Wizard requires that you specify the components to be configured.
IMPORTANT: The configuration tools produce a configuration file that can be used to
automatically reconfigure your system after an upgrade. If you use the tools to reconfigure your
server after the original configuration has been done, make sure you reconfigure all of the
components that are installed on the system (this is the default).
6 (Conditional) If you are using the PlateSpin Orchestrate product configuration script, run the
script:
6a Make sure you are logged in as
6b Run the script, as follows:
/opt/novell/zenworks/orch/bin/config
When the script runs, the following information is initially displayed:
Welcome to PlateSpin Orchestrate.
This program will configure PlateSpin Orchestrate 2.0
Select whether this is a new install or an upgrade
i) install
u) upgrade
- - - - - -
Selection [install]:
6c Determine whether this is a new installation or an upgrade.
This example procedure discusses standard installation, so specify
Enter to accept the default. For more information about upgrade, see the
Orchestrate 2.0 Upgrade
When you make the selection, the following information is displayed:
Select products to configure
Select from the following:
Selection [finish]:
24 PlateSpin Orchestrate 2.0 Installation and Configuration Guide
Step 6.
Guide.
# selected Item
1) yes PlateSpin Orchestrate Monitoring Service
2) yes PlateSpin Orchestrate Server
3) yes PlateSpin Orchestrate Agent
4) yes PlateSpin Orchestrate VM Builder
1 - 4) toggle selection status
a) all
n) none
f) finished making selections
q) quit -- exit the program
to run the configuration script.
root
Step 7.
(for install) or press
i
PlateSpin