Novell PLATESPIN ORCHESTRATE 2.0.2 - INSTALLATION AND CONFIGURATION GUIDE 10-09-2009 Installation And Configuration Manual page 51

7g Confirm that the Orchestrate Agent is selected for configuration, then click Next to display
the Orchestrate Agent Configuration page:
7h Check and if necessary change the name of the Orchestrate Agent and the Orchestrate
Server.
If you select the Configure Advanced Settings check box in the wizard, you have the
option of changing the default values. If you leave the check box deselected, the setting is
configured with normal defaults. For information about the advanced settings see
Section 2.2.2, "PlateSpin Orchestrate Configuration Information," on page
7i Click Next to display the configuration wizard summary page:
IMPORTANT: Although this page of the wizard lets you navigate by using the Tab key
and the spacebar, you need to use the Ctrl+Tab combination to navigate past the summary
list. Click Back if you accidentally enter the summary list, and re-enter the page to
navigate to the control buttons.
By default, the Configure now check box on this page is selected. If you accept the default
of having it selected, the wizard starts the PlateSpin Orchestrate Agent and applies the
configuration settings. If you deselect the check box, the wizard writes out the
configuration file to
without starting PlateSpin Orchestrate or applying the configuration settings.
/etc/opt/novell/novell_zenworks_orch_install.conf
30.
Installation and Configuration 51