IMPORTANT: Although this page of the wizard lets you navigate by using the Tab key
and the spacebar, you need to use the Ctrl+Tab combination to navigate past the summary
list. Click Back if you accidentally enter the summary list, and re-enter the page to
navigate to the control buttons.
By default, the Configure now check box on this page is selected. If you accept the default
of having it selected, the wizard starts PlateSpin Orchestrate and applies the configuration
settings. If you deselect the check box, the wizard writes out the configuration file to
etc/opt/novell/novell_zenworks_orch_install.conf
Orchestrate or applying the configuration settings.
You can use this
.conf
either manually or with an installation script. Use the following command to run the
configuration:
/opt/novell/zenworks/orch/bin/config -rs
7h Click Next to display the following wizard page.
7i Click Next to launch the configuration script. When the configuration is finished, the
following page is displayed:
7j Click Finish to close the configuration wizard.
file to start the Orchestrate Server or Agent and apply the settings
/
without starting PlateSpin
Installation and Configuration
29