6k (Optional) Specify a local bind address for the Agent, then press Enter.
6l Verify the configuration summary information, specify whether changes are needed, then
(when all changes are made) press Enter to begin the configuration.
7 (Conditional) If you use the GUI Configuration Wizard, run it as follows:
7a Make sure the product ISO is accessible. The script copies some files from the ISO.
7b Make sure you are logged in as
7c Run the wizard:
/opt/novell/zenworks/orch/bin/guiconfig
When the script runs, the following information is initially displayed:
IMPORTANT: If you have only a keyboard to navigate through the pages of the GUI
Configuration Wizard, use the Tab key to shift the focus to a control you want to use (for
example, a Next button), then press the spacebar to activate that control.
Default values are built into the script; most of these defaults are set to configure all of the
product patterns that were installed using the Add-on Product Media utility in SLES 9 and
in SLES 10.
7d Click Next to display the license agreement:
to run the configuration wizard.
root
Installation and Configuration
49