Novell PLATESPIN ORCHESTRATE 2.0.2 - INSTALLATION AND CONFIGURATION GUIDE 10-09-2009 Installation And Configuration Manual page 42

The easiest way to configure the audit database is to do so when you configure the PlateSpin
Orchestrate Server. Use the following procedure to configure the database.
NOTE: The questions presented in the text-based config script are shown here, but the questions
presented in the graphical Configuration Wizard are similar.
1 After you have installed the PlateSpin Orchestrate packages you want, run the configuration
(either the config script or the graphical Configuration Wizard) until you see the following
question:
Enable Auditing (y/n) [no]:
2 Enter
Configure Audit DB (y/n) [no]:
3 Enter
Jdbc URL [jdbc:postgresql://localhost/]:
4 Press Enter to accept the default (
This is a standard JDBC URL because this is a Java server that uses JDBC for the interface
database. The URL must be properly formed, with a slash and without a database name at the
end.
The following prompt is displayed:
DB Admin Username:
5 Specify the PostgreSQL database administrator username, then press Enter.
This is the same name that was specified when PostgreSQL was installed. In most instances,
the username is
The following prompt is displayed:
DB Admin Password:
6 Specify the PostgreSQL database administrator password, then press Enter.
The following prompt is displayed:
Retype password:
7 Retype the database administrator password to verify it, then press Enter. The following prompt
is displayed:
ZOS Audit Database Name [zos_db]:
8 Specify the name of the database you want to create for PlateSpin Orchestrate auditing, then
press Enter. The following prompt is displayed:
Audit DB Username:
9 Specify the name you want to use for the PostgreSQL database user that will be used by
PlateSpin Orchestrate for auditing (that is, a user with Read and Write privileges, not the
administrator), then press Enter. The following prompt is displayed:
Audit DB Password:
10 Specify the password you want to use for authentication by the designated PostgreSQL
database user, then press Enter. The following prompt is displayed:
Retype password:
11 Retype the password, then press Enter.
42 PlateSpin Orchestrate 2.0 Installation and Configuration Guide
to answer this question. The following question displays:
yes
to answer this question. the following question displays:
yes
.
postgres
jdbc:postgresql://localhost/
) by pressing Enter.