Table of Contents
Advertisement
[14] FNS Adjusting the Sub-tray Paper
Exit Gate
1. Tools used
• Phillips-head screwdriver
• Scale
2. Preparation
(1) Remove the 2 set screws holding the FNS CB
(FNS control board) in place. Remove the FNS
CB together with its bracket.
Bracket
Screws
(2) Remove the wirings from the clamps, and move
the FNS CB together with its bracket.
Clamps
Clamp
Clamps
(3) With SD2 (sub-tray paper exit) OFF, measure the
gap between the sub-tray gate and the guide
plate (indicated by A in the illustration).
Spec value for gap: A = 4 ±0.5mm.
FNS CB (Finisher Control Board)
Clamps
Clamps
Clamps
1 - 121
(4) With SD2 ON, measure the gap between the
solenoid plunger and the bracket stopper (indi-
cated by B in the illustration).
Spec value for gap: B = 5 ±0.5mm.
SD2
Sub-tray Gate
(Sub-tray
Paper Exit)
(5) If either gap is out of spec, carry out adjustment
as described below.
3. Adjustment Procedure
(1) Loosen the 2 set screws holding the solenoid in
place, and move the solenoid as necessary to
adjust.
Screws
(2) Retighten the screws.
(3) Reinstall in opposite sequence to removal.
OTHER ADJUSTMENT
Solenoid
Advertisement
Table of Contents
