Table of Contents
Advertisement
3.
Adjustment of pick-up release amount of
LCT
Paper feed roller
Pick-up solenoid
Paper up/down
plate
Screw
1 - 113
a.
Adjustment method
Step
1
Move the paper up/down plate up.
2
Open the top cover.
3
Remove the spring from the paper
pick-up roller unit.
Top cover
Paper feed roller unit
4
Pull the movable portion of the pick-up
solenoid and check whether the distance
between the bottom of the paper feed roller
and the top surface of the paper up/down
plate is within specifications.
Standard value: 0.5 to 2.5 mm
If the distance is not within specifications,
perform steps 5 and later.
5
Loosen one screw to adjust the mount-
ing position of the pick-up solenoid.
Caution: Take a note to remember the
initial mounting position.
6
Secure the pick-up solenoid by tighten-
ing the screw.
7
Install the spring.
8
Close the top cover.
OTHER ADJUSTMENT
Operation
Spring
Remove
Paper feed roller
unit
Advertisement
Table of Contents
