Table of Contents
Advertisement
OTHER ADJUSTMENT
b.
Adjustment Method (when Some of Printed
Sheets are Skewed Irregularly)
Step
Operation
1
Print a test pattern (No.16) in the con-
tinuous copy mode to check for skew.
2
Remove the side cover (right).
3
Loosen the five screws securing the
guide plates (font and rear) and the
centering positioning bracket temporar-
ily. Press the guide plates (front and rear)
against paper, then tighten the five
screws.
Guide plate(front)
Screws
C-305
Screw
Centering positioning
bracket
Reference: The indicated size of each guide plate
is about 2 mm wider than the size of
regular paper. The 2 mm gap may
cause paper skew depending on the
paper type. To reduce this skew,
press the guide plates (front and rear)
against paper tightly.
Guide plate(rear)
Screws
C-305L
Screw
Centering positioning
bracket
1 - 106
4.
ADU (Rear side) Skew Adjustment
a.
Adjustment Method
Step
Operation
1
Draw out the ADU stand and detach the
ADU cover.
2
Loosen the two screws to slide the pre-
registratin roller unit installation position.
3
Secure the fixing plate by tightening the
two screws firmly.
4
Install the ADU cover and set the ADU
stand.
Advertisement
Table of Contents
