Table of Contents
Advertisement
OTHER ADJUSTMENT
Standard value of mis-centering: ±3 mm
±3 mm
4.
Setting the LCT Rear Guide
(C-305L only)
Rear guide
Screw
Image center
Paper center
Screws
Rear guide
a.
Adjustment Method
Step
1
Open the top cover.
2
Press the SW100( LT tray down switch)
to lower the up/down plate to the bottom.
3
Loosen the two screws at the top of the
rear guide and one screw at the bottom.
4
Set paper on the up/down plate, align the
trailing edge of paper with the lower end
of the rear guide, then fasten the lower
screw.
5
Fasten the two upper screws temporarily
and move the up/down plate to the high-
est position.
6
Set paper on the up/down plate, align the
trailing edge of paper with the upper end
of the rear guide, then tighten the two
upper screws finally.
Reference: LCT tray size setting can be per-
formed in the key operator mode by
setting the DIPSW21-1 to 1 in the
25 mode .
1 - 100
Operation
Advertisement
Table of Contents
