Table of Contents
Advertisement
OTHER ADJUSTMENT
a.
Adjustment Method
Step
1
To remove the tray with the up/down plate
up, set the tray with a small thing (eraser,
etc.) inserted under the up/down drive
linkage lever.
2
Make sure that the up/down plate has
moved up by hearing the motor sound,
then draw out the tray.
3
Remove the two screws to remove the
tray from the left and right guide rails.
4
Loosen a screw and adjust the position
of the up/down pulley so that the front
and rear ends of the up/down plate are at
the same height.
5
Secure the up/down pulley by tightening
the screw firmly.
6
Secure the tray on the guide rails.
7
Set the tray.
Operation
Eraser or the like
Up/down dive linkage
lever
1 - 102
3.
LCT Up/Down Plate Horizontality Adjust-
ment
Up/down plate
Up/down plate
Screws
Up/down pulley
Adjusting
screws
Up/down pulley
Screws
Advertisement
Table of Contents
