Table of Contents
Advertisement
3.
Cover sheet tray size adjustment
(Cover Inserter A only)
This adjustment should be performed when the
cover sheet tray size cannot be detected prop-
erly.
Step
1
Enter the 36 mode.
2
[36 Mode Menu Screen]
Press "
Finisher adjustment."
6
3
[Finisher adjustment mode menu
Screen]
Press "
Cover sheet tray size adj."
3
4
Move the side guide plates of the cover
sheet tray to the outmost positions re-
spectively and press the
the LCD. An end message appears on
the screen.
Width
Side
Regulation Plates
guide plates
5
Press the
PREVIOUS SCREEN
turn to the Finisher adjustment mode
menu Screen.
Operation
key on
Start
key to re-
1 - 81
4.
Trimming stopper adjustment
(TMG-1 only)
Adjusting the trimming amount.
Step
1
Enter the 36 mode.
2
[36 Mode Menu Screen]
Press "
Finisher adjustment."
6
3
[Finisher adjustment mode menu
Screen]
Press "
Trimmer stopper adjustment."
4
4
[Trimming stopper adjustment Screen]
Press the
COPY SCREEN
5
Set paper in the tray, set originals on
RADF , and press the Start button.
6
Check the trimming amount.
Specification: 2-4 mm
Note: Setting a trimming amount of 2 mm
or less may cause a trimming error.
7
If the trimming amount is not within
specs, press the C button while pressing
the Utility button.
8
[Trimming stopper adjustment Screen]
Press the
NEXT ADJUSTMENT
PREVIOUS ADJUSTMENT
desired paper size.
9
Enter a value with numeric keys and
press the
SET
Setting range: -99 to +99
1 step=0.1 mm
10
Repeat steps 4-9 until the trimming
amount is within specs.
11
Press the
PREVIOUS SCREEN
turn to the Finisher adjustment mode
menu Screen.
36 ADJUSTMENT
Operation
key.
or
key to select a
key.
key to re-
Advertisement
Table of Contents
