Table of Contents
Advertisement
3.
LCT tray centering adjustment
Guide plate/front
Screws
C-305
Screw
Center positioning
bracket
Guide plate/rear
Screws
Screws
Center positioning
bracket
C-305L
Screw
Center positioning
bracket
1 - 99
a. Adjustment method
Step
1
Move the paper up/down plate.
2
Open the top cover.
3
Remove the four screws to detach the
side cover (right).
Side cover
(right)
4
Loosen the two screws to slide the upper
and lower guide plates the same amount
in the same direction.
5
Secure the upper and lower guide plates
by tightening two screws firmly.
6
Loosen the two screws to slide the center
positioning bracket in the same manner
as for the upper and lower guide plates
(same amount and same direction).
7
Secure the centering piece by tighten-
ing two screws firmly.
8
Put the LCT back into the original
position and make a copy to check the
result.
9
Perform steps 1-8 repeatedly until mis-
centering is included in the automatic
adjustment range (±3 mm).
Caution: Disable the mis-centering correction
function by setting the dip switch 12-
3(DIPSW12-3) and confirm it. Confirm
it
using
No.16.(Enter 1 to set to ON)
OTHER ADJUSTMENT
Operation
Screws
Screws
the
inter nal
patter n
Advertisement
Table of Contents
