Remote Node Network Layer Options; Figure 19-3 Menu 11.3 Remote Node Network Layer Options; Table 19-2 Menu 11.3 Remote Node Network Layer Options - ZyXEL Communications Prestige 861H-G1 User Manual

Prestige 861H User's Guide

19.3 Remote Node Network Layer Options

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node
Network Layer Options as shown next.
1. In menu 11.1, make sure IP is among the protocols in the Route field.
2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Menu 11.3 - Remote Node Network Layer Options
IP Options:
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=

Figure 19-3 Menu 11.3 Remote Node Network Layer Options

The next table explains fields in Menu 11.3

Table 19-2 Menu 11.3 Remote Node Network Layer Options

FIELD
IP Address Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote
Assignment node is using a dynamically assigned IP address or Static if it is using a
static (fixed) IP address. You will only be able to configure this in the ISP
node (also the one you configure in menu 4), all other nodes are set to
Static.
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet Type the subnet mask assigned to the remote node.
Mask
My WAN Some implementations, especially UNIX derivatives, require separate IP
Addr network numbers for the WAN and LAN links and each end to have a unique
address within the WAN network number. In that case, type the IP address
assigned to the WAN port of your Prestige.
NOTE: Refers to local Prestige address, not the remote router address.
19-4
Enter here to CONFIRM or ESC to CANCEL:
Remote Node Network Layer Options.
–
DESCRIPTION
Bridge Options:
Ethernet Addr Timeout(min)= 0
Remote Node Configuration
EXAMPLE
Dynamic