Ip Routing Commands; Global Routing Configuration; Table 37-2 Global Routing Configuration Commands - SMC Networks TigerStack II SMC8848M Management Manual

IP R C
OUTING OMMANDS

Global Routing Configuration

Command
ip routing
ip route
clear ip route
show ip route
show ip host-route
show ip traffic
ip routing
This command enables IP routing. Use the no form to disable IP routing.
Syntax
[no] ip routing
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• The command affects both static and dynamic unicast routing.
• If IP routing is enabled, all IP packets are routed using either static
routing or dynamic routing via RIP or OSPF, and other packets for all
non-IP protocols (e.g., NetBuei, NetWare or AppleTalk) are switched
based on MAC addresses. If IP routing is disabled, all packets are
switched, with filtering and forwarding decisions based strictly on
MAC addresses.
37-2

Table 37-2 Global Routing Configuration Commands

Function
Enables static and dynamic IP routing
Configures static routes
Deletes specified entries from the routing
table
Displays specified entries in the routing
table
Displays displays the interface associated
with known routes
Displays statistics for IP, ICMP, UDP, TCP
and ARP protocols
Mode Page
GC 37-2
GC 37-3
PE 37-4
PE 37-5
PE 37-6
PE 37-7