Enabling The Snmp Agent; Figure 5-1 Enabling The Snmp Agent - SMC Networks TigerStack II SMC8848M Management Manual

S N
IMPLE ETWORK

Enabling the SNMP Agent

Enables SNMPv3 service for all management clients (i.e., versions 1, 2c, 3).
Command Attributes
SNMP Agent Status – Enables SNMP on the switch.
Web – Click SNMP, Agent Status. Enable the SNMP Agent by marking
the Enabled checkbox, and click Apply.
CLI – The following example enables SNMP on the switch.
Console(config)#snmp-server
Console(config)#
Setting Community Access Strings
You may configure up to five community strings authorized for
management access by clients using SNMP v1 and v2c. All community
strings used for IP Trap Managers should be listed in this table. For
security reasons, you should consider removing the default strings.
Command Attributes
• SNMP Community Capability – The switch supports up to five
community strings.
• Current – Displays a list of the community strings currently configured.
5-4
M
ANAGEMENT

Figure 5-1 Enabling the SNMP Agent

P
ROTOCOL
21-2